INSTALLATION (Continued)
Refer to Figure 4. If a NuTone Volume Control is installed in the system, connect the control’s
NuTone speaker may be connected to each volume control. Each volume control/speaker counts as a remote station. Remember: The maximum remote connections to the Master Station is 9. Adding the optional
Refer to the installation instructions packed with the speaker
ORN |
ORN/WHT |
FIGURE 4
NEVER USE 8 OHM STEREO SPEAKERS
WITH THIS SYSTEM!
volume control for wiring this unit.
CONNECTING DOOR SPEAKER WIRING
The Door Speakers connect to the Master Station Terminal Board with twisted pair
1.Refer to Figure 5. Connect the two wires from the Door Speaker(s) to the 2 screw terminals marked DOOR SPEAKER on the master station terminal board.
DOOR | FIGURE 5 |
SPEAKER |
PREPARING MASTER STATION PANEL FOR OPTIONAL DOOR RELEASE PUSHBUTTON
To remove the pushbutton cover, position the master station face up. Be careful not to damage the cables on the back of the unit.
1.Refer to Figure 6. Open the
FIGURE 6 |
2.Cut the 4 retainer webs from the pushbutton cover.
3.Remove cover. The door release pushbutton will be installed and connected after the master panel has been mounted to the
MOUNTING THE OPTIONAL CHIME MODULE IN THE MASTER STATION PANEL
1.Position the master station panel face down on a soft cloth.
2.Refer to Figure 7. Align the optional NuTone
| SNAP IN PLACE |
RED |
|
WIRE |
|
FIGURE 7 |
3.Apply firm, but even pressure to each side of the chime module until it snaps into place.
4.Plug the 4 pin connector on the module into the connector located on the master. When properly installed, the ribbon cable will point away from the master station’s circuit boards, as illustrated.
5.Connection from the pushbuttons to the master will be made after the master panel has been mounted.
5
