TROUBLESHOOTING
The range of the door chime de- pends on location, temperature and battery condition. If you are having problems with this product, please try the solutions listed below.
Chime rings on its own:
•Button frequency jumpers and chime frequency jumpers must be set to the same frequency code. Change the button frequency jumpers and chime frequency jumpers to a dif- ferent code.
BATTERY PUSH
BUTTON
{
Button Frequency Jumpers
(inside pushbutton case)
Chime Fre- quency Set Jumpers
1 6
+ | - | + |
|
FREQUENCY CODE
- SAMPLE SETTING -
Button Frequency Jumpers
(Jumpers removed (OFF) from 2, 4, 6)
Chime Frequency Jumpers
(Jumpers removed (OFF) from 2, 4, 6)
Batteries are OK, but chime does not work when installed:
•Mounting the chime or button directly on metal, concrete or near metal studs reduces the range. Use 1/4” to 1/2” wood shims to move the chime or doorbell button off of the surface.
•Do not mount the chime too close to ground level concrete slabs which may also reduce the range. Mount the chime away from the floor.
•Try different locations for the chime closer to the button. Also, try to orient the chime at a differ- ent angle to increase the range. Range is most effective to the sides of the button.
Chime doesn’t sound:
•Make sure the button and the chime are set to the same frequen- cy code.
•Replace the button battery. Also check chime batteries.
Regulatory Information
The user is cautioned that changes or modifications not expressly ap- proved by the party responsible for regulatory compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC rules. Operation is sub- ject to the following two conditions:
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that may cause undesired operation.
