5.Separate and strip approx 1/2" of insulation from each of the eight wires in the cable. Twist the following cables together:
•OR and OR/WH
•GR and GR/WH
•BL and BL/WH
•BR and BR/WH
6.Remove the plastic back frame and rubber gasket from the camera. Position the back frame and gasket over wire and attach to the wall box using (2) #6 x 3/4" machine screws (supplied). Level the back frame before tightening screws completely.
7.Attach each of the twisted pair of wires to the corresponding screw terminal on the back of the camera. Tighten each screw securely.
8.Dress extra cable into wall box and position the camera, starting at the top of the plastic back frame.
9.Fully seat the camera into the back frame and secure the camera with 4mm screw (supplied) thru the bottom of the back frame and camera.
Important: If camera is exposed to outside elements, caulk should be added to the top and sides of the cam- era at the wall surface. Do not caulk bottom surface.
Existing Construction
1a. At the camera location, a single gang wall box can be cut into the existing wall surface (maybe required by local code). Normal height is 58" from center of the hole to the floor.
1b. At the camera location, drill a 3/8" hole into the wall directly next to a wall stud. Normal mounting height is 58" from the center of the hole to the floor.
2.Run the category 5 or category 6 cable from the TV/Monitor location to the camera location (250 ft maximum length).
3.Run the cable thru the hole (or into the box if used). Leave approx 12" of extra cable protruding thru the hole (or box if used).
4.Strip approx. 2" of outer protective jacket from the category 5, or category 6 cable.
13
