FM Folded Dipole Antenna with 20 foot lead-in

The folded dipole antenna with a 20' lead is designed to be mounted in the homes attic. If additional lead-in length is needed, additional 300 ohm “twin lead” cable can be attached. Use one of the following methods to install the FM antenna.

Stapling

Use staples to attach twin lead wire to rafters, or joists. Insert the staple lengthwise in the plastic between the wires.

Do not staple across the wire.

Staple

Antenna

Through

Center

Nailing

Nails may be used to attach the twin lead wire to rafters or joists. Place nails in the plastic between the two wires.

Do not nail over or through a wire. Do not wrap the twin lead wire around a nail.

Nails may be used to attach the plastic center block and the two plastic end caps. Use nail holes provided in these pieces.

Center Block

Nail

Antenna

Through

Center

Nail Holes

End Cap

Attic Rafter

Staple antenna to attic rafters horizontally.

Nail a 5 foot piece of scrap board horizontally between rafters to provide a clear span of 60". Nail the center block of the center of the board. Staple antenna leads to board.

9

Page 9
Image 9
NuTone VSUC4SK installation instructions FM Folded Dipole Antenna with 20 foot lead-in, Stapling, Nailing, Attic Rafter