Nuvo NV-E6DXS, NV-E6DMS XIV. Changing the Buttons on the, Essentia Keypad Fig, NV-RC2Remote

XIII. The NV-RC2 IR Remote Control

(Fig. 13)

The Essentia System comes with the RC2 remote con- trol. This remote allows wireless control of all of the keypad functions, as well as the functions of the NuVo T3 Tuner. The four-backlit buttons at the top of the remote allow you to choose which device the remote will control. The numeric keypad is used to choose the desired audio source, or tuner preset.

The RC2 remote is an ideal tool for teaching the NuVo System functions to a universal learning remote con- trol that can then operate the Essentia system as well as all the individual source functions.

NV-RC2 Remote Learning Remote

Fig. 13: NV-RC2 IR Remote Control

XIV. Changing the Buttons on the

Essentia Keypad (Fig. 14)

The Essentia keypads ship with 36 preprinted inter- changeable source buttons. This allows you to easily customize each keypad to match the audio components being used in the system.

To change the buttons use a small screwdriver to remove the outer Decora insert. This exposes two inner plates that hold the buttons in place. Those are also removed with a small screwdriver, allowing you to remove and replace the desired source buttons.

LED14	LED15 LED16
LED13	LED17
LED12	LED18
VOLUME
ON	ALL
OFF	OFF

CD1 CD2

TNR1 TNR2

TNR3 SAT

Line up the tabs on the replacement buttons with the

corresponding holes in the keypad’s circuit board. Fig. 14 Once the new buttons are in place return the inner

plates and the outer keypad insert.

20