Nuvo NV-E6DMS, NV-E6DXS owner manual Step

Step 7:

Connect the provided pre-terminated network Cable in the RJ-45 connection jack on the front of the EZ Port and in the Network Connection on the back of the Essentia amplifier.

Step 8:

Each zone is easily set using the DIP switches located on the back of the keypad. Switches 1-4 are used to set a unique address for each zone and are noted with a "1" indicating the down position of the switch and a "O" indi- cating the up position. Refer to the chart on the back of the keypad for the correct switch position for each zone. Page 17 provides a visual reference of all of the available switch settings.

Step 9:

Switches 5, 6, & 7 are used to adjust the amount of bass and treble response in each zone. There are eight possi- ble settings. The choices are a bass and treble boost, two levels of bass boost, two levels of treble boost, bass cut, treble cut, or flat. The positions for these settings are also shown as "1" for down and "O" for up and are shown on page 18.

Step 10:

Switch 8 allows multiple zones to share the same source. This is useful for large living spaces such as a kitchen, breakfast nook, and dinning room where there are no walls defining each room. When switch 8 is in the up "O" position, all keypads with the same setting will then always turn on at the same source. This does, however, allow individual volume and on/off control. This setting is shown on page 18.

Step 11:

Switch 9 sets the volume level when the zone is turned on. The choices are to have the zone turn on at the same level it was at when it was previously turned off (switch 9 in the down "1" position), or to turn on at a low volume level (switch 9 in the up "O" position). This setting is shown on page 19.

Step 12:

Once the desired switch settings have been made for each keypad and they have been installed in their zone loca- tions, you will be able to turn each zone on and off, control volume, and choose audio sources independently. These functions can also be done wirelessly using the NuVo RC2 remote control. The built-in IR receiver in each keypad also allows for direct control of the audio source equipment using that equipment’s remote control or a universal learning remote control.

7