Connecting Internal Headers
Front Panel Header
The front panel header on this
motherboard is one connector used to
connect the following four cables:
•PWRLED
Attach the front panel power LED
cable to these two pins.The Power
LED indicates the system’s status.
When the system is in S0 status,
the LED is on.When the system is
in S1,S3, S4 or S5 status, the LED
is off.
Note: The power LED cable in some chassis is a three pin connector with the pins
installed in positions 1 and 3.If your chassis has a three pin connector, you will need to
remove pin 3 and put it into position 2 or you can use a pair of scissors to cut out
position 2.Most chassis come with a two pin connector.
•PWRSW
Attach the power button cable from the case to these two pins.Pressing the power
button on the front panel turns the system on off rather than using the power
supply button.
•HD_LED
Attach the hard disk drive indicator LED cable to these two pins.The HDD indicator
LED indicates the activity status of the hard disks.
•RESET
Attach the Reset switch cable from the front panel of the case to these two pins.The
system restarts when the RESETswitch is pressed.
18
Installing and Configuring the BFG NVIDIA nForce 680i LT SLI Motherboard
9
10
1
2
Connect
Blank