Olympia P60 manual Troubleshooting, Display, Settings and Power Supply, 121

Troubleshooting

If the camera fails to function as expected, check the list of common problems below before consulting your retailer or Nikon-authorized service representative. Refer to the page numbers in the right-most column for more information.

Display, Settings and Power Supply

Problem		Cause/Solution	A
Monitor is blank.	•	Camera is off.	20
	•	Batteries are exhausted.	20
	• Standby mode for saving power: press the		15, 24
		shutter-release button halfway.
	• Monitor and electronic viewfinder cannot be		8
		used simultaneously. Press xto alternate
		between displays.
	• Wait until flash has charged.		29
	• Camera and computer are connected via USB		63
		cable.
	• Camera and TV are connected via audio/video		62
		cable.
Monitor is hard to read.	•	Ambient lighting too bright: use electronic	22
	•	viewfinder or move to darker location.
		Adjust monitor brightness.	102
	• Monitor is dirty. Clean monitor.		116
	• Monitor has dimmed to save power. Monitor		15
		brightens when controls are used.
Camera turns off without	•	Batteries are low.	20
warning.	•	Camera has turned off automatically to save	15
	•	power.
		Batteries are cold.	115
Date and time of recording are	•	Pictures recorded before clock was set, and	16
not correct.		“Date not set” indicator blinks during shooting,		Technical
		will have time stamp of “00/00/0000 00:00”;
		movies and voice recordings will be dated “01/
		01/2008 00:00.”		Notes
	• Check camera clock regularly against more		99
		accurate timepieces and reset as required.
No indicators displayed in	Shooting data and photo information may be		8
monitor.	hidden. Press xuntil shooting data or photo
	information will be displayed.

121