Omega Vehicle Security DPS3300 manual Trouble Shooting, Error Messages and Solutions

TROUBLE SHOOTING

If the meter locks on a particular display, unplug and plug in again to unlock the display. A total reset clears the memory and defaults all values to zero. To perform this reset, re-apply power with RESET key pressed in.

Factory Channel settings:

To obtain factory preset values simply re-apply power with SDIGT key pressed in. This will also clear memory of any erroneous values and is the preferred method of resetting a unit that might be malfunctioning due to corrupted memory .

Factory default settings for Thermocouple, voltage, current and milli-volt are:

PARAMETER	CURRENT	VOLTAGE.	MILLIVOLT	T/C
	INPUT	INPUT	INPUT	INPUT
HIGH SCALE	20.000	10.000	100.00	J
LOW SCALE	0.000	0.000	0.000	J
OFFSET	0.00	0.00	0.00	J
TARE	0.000	0.000	0.000	J

ERROR MESSAGES AND SOLUTIONS

ERROR MESSAGES AND SOLUTIONS

ERROR MESSAGE	ERROR CONDITION	SOLUTION
'EE EROR'	The unit was unable to	If the message keeps coming up,
	save programmed value	unplug the unit and reapply power.
	in EEPROM -- possible	If the unit still displays the error
	failure of EEPROM.	message, send it in for repair.
		If error message followed by
		8.8.8.8.8.8.8.and the revision
		number are displayed occasionally,
		it is an indication that power
		line is very noisy and needs a line filter.
'CARD ER'	Too much noise on	1. If message shows occasionally,
	input signals or problem	it indicates that input signal s have
	with Scanner card.	too much high voltage noise.
		Provide signal filters.
		2. Unplug and plug the meter again
		to recycle power.
		3. Scanner card defective -- send in
		for repair
'HIGH AC NOISE'	High AC noise on input	1. If message shows occasionally,
	signals or incoming AC	it indicates that input signals or
	line interfering with the	AC line has too much high
	operation of the unit	voltage noise.
		2. Provide line and signal filters.

Page 26