Omega Vehicle Security DPS3300

Page 23

NOTE: LOOK UNDER SPECIFICATIONS FOR THE RATING ON RELAYS AND OPEN COLLECTOR

OUTPUTS. UNDER NO CONDITION SHOULD THE RELAYS AND OPEN COLLECTOR

OUTPUTS BE OPERATED BEYOND THEIR RATED CAPACITY. DOING SO CAN DAMAGE

THE UNIT PERMANENTLY.

The status of the relays for all the channels is indicated on the front panel by a row of LEDs. Whenever the relay is

energized, its respective LED is turned on.

FIG- 3. DPS3300 Series TERMINAL COMPARTMENT

INPUT CONNECTOR OUTPUT CONNECTOR

Pin 1 Pin 14

GND

POWER INPUT

CONNECTOR

Contents

Main Page Page SPECIFICATIONS Page DESCRIPTION DISPLAYING PARAMETERS Table 1. How to Display Parameters DISPLAY MODES Table 2. Display Modes Elapsed Time Mode Scan Mode High/Low Channel Mode Deviation Mode Types of Deviation Displays Difference Mode SETUP CH Parameter List CHANNEL CONFIGURATION Setup For Input Type Setup for Voltage or Current Input: Setup For Channel ON/OFF Setup For Decimal Point Position Setup For High Scale Setup For Low Scale Setup For Offset Setup For Tare Setup For Setpoint Setup for Universal Relay (Channel 1 Relay) Setup For Limits Setup For Deadband Setup For Relay Normally Open/Closed Setup for Thermocouple/ Thermistor/ RTD Inputs: Turning Channels ON/OFF: Temperature units: Setup Examples Example #1: Use of the OFFSET Parameter SYSTEM CONFIGURATION Setup For Display Options Table 3. Display Options Setup For Display Time Setup For Relay Latch/Non-Latch Relay Latched Mode: Relay Non-Latched Mode: Setup for Buzzer Setup For Channel Calibration Input Range Setup (for current and voltage): Voltage Range Setup (0-10vdc, 0-5vdc) Voltage Range Setup (for millivolt inputs) Current Range Setup SAVING PARAMETER: PEAKS PROGRAMMING FLOW CHARTS: FOLLOWING PAGES SHOW FLOW CHARTS FOR DPS3300 UNITS: DPS3317 7 Channel Unit DPS3314 4 Channel Unit DPS3307 7 Channel Unit DPS3304 4 Channel Unit RATE LIMITS OUTPUT 8 OUTPUTS Page 8910 11 12 13 6 5 4 3 2 1 7 14 POWER DOUBLE CHECK THE CONNECTIONS BEFORE APPLYING POWER!! INPUT CONNECTOR PIN ASSIGNMENT DIRECT INTERFACE TO UNIVERSAL RELAY MODULE TROUBLE SHOOTING Factory Channel settings: ERROR MESSAGES AND SOLUTIONS MOUNTING Figure - 4. Rear View And Mounting Hole Locations WARRANTY