OFA 6L with Learning Owners Manual.fm Page 12 Thursday, February 17, 2005 1:10 PM

ONE FOR ALL 6L UNIVERSAL REMOTE CONTROL WITH LEARNING

3.To stop scanning channels at any time, press any key once.

PROGRAMMING FAVORITE CHANNEL SCAN

In the TV, VCR, DVD or CBL/SAT mode, you can store a list of up to 10 favorite channels, in any order, that will be immediately scanned when you press FAV (see “Using Channel Scan” on page 11).

NOTE: Only channels of one mode can be stored for Favorite Channel Scan.

1.On the remote control, press TV, VCR,

DVD or CBL/SAT once.

2.Press and hold SET until the LED (red light) blinks twice, then release SET.

3.Enter 9 9 6. The LED will blink twice.

4.Use the keypad to enter a favorite channel number (e.g., 031). Then press SET once.

NOTE: If the original remote control required pressing an ENTER key to change the channel, also press the ENTER key after the channel number (e.g., 0 3 1 ENTER).

5.If desired, repeat step 4 (in this section) for each favorite channel to be stored, up to a total of 10 channels.

NOTE: If you try entering more than 10 channels, the remote control will automatically exit programming.

6.To exit programming, press and hold SET for 3 seconds. The LED will blink twice.

USING LEARNING

The One For All 6L Universal Remote Control with Learning (URC-6820 B00)

includes a Learning feature so you can add functions that are unique to your home entertainment devices (e.g., DVD EJECT). However, there are some considerations.

LEARNING PRECAUTIONS

Your original remote controls must be in working order for learning to work properly.

Learned keys are mode specific, so each one can store a unique function for each mode.

Learned keys can be used in macros (see “Using Macros” on page 9).

Do not use the following keys for learning: Device Keys, SETUP, FAV, or Record () Key.

Learning capacity is approximately 50 to 70 keys, depending on the code being learned.

If both learned and keymoved functions are assigned to the same key, the last programmed function is stored.

A learned function cannot be used as a source for Keymover (see “Using Keymover” on page 14).

Certain device codes are not learnable including multi-frequency types, some high frequency ones, and other unusual formats.

For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient fluorescent lights.

NOTE: Please have your original remote controls handy before programming learning. Be sure to press each teaching key within 5 seconds of the previous entry. Otherwise, the One For All 6L Universal Remote Control with

12 Programming Favorite Channel Scan

Page 13
Image 13
One for All 6-Device Universal Remote owner manual Using Learning, Programming Favorite Channel Scan, DVD or CBL/SAT once