One for All 6-Device Universal Remote Setting UP Your Components, Setting Up Your Components

OFA 6L with Learning Owners Manual.fm Page 7 Thursday, February 17, 2005 1:10 PM

4.Test the remote control by first pressing POWER and then any mode key (e.g., TV). If the batteries are inserted correctly, the LED (red light) will blink once.

NOTE: When batteries are low, the remote control will blink 5 times after each key press. The remote will stop operating when the batteries need replacement. The permanent memory retention ensures that your codes are stored permanently even during battery replacement.

SETTING UP YOUR

COMPONENTS

The One For All 6L Universal Remote Control with Learning (URC-6820 B00) is preprogrammed at the factory to operate a Sony TV, DVD and VCR, a Motorola Cable Box, a Sony Tivo PVR/DVR, and a Pioneer Receiver. To control devices other than the default brands, perform the following steps; otherwise skip this section.

NOTE: For Combo Device control, see the next section.

1.Turn on a device (e.g., TV, VCR or DVD player) and, if applicable, insert media (e.g., cassette or disc).

NOTE: Please read steps 2 through 4 completely before proceeding. Highlight or write down the codes and device you wish to program before starting step 2.

2.On the remote control, press a device key once (i.e., TV, CBL/SAT, VCR, DVD, PVR, or AUD).

3.Press and hold SET until the LED (red light) blinks twice, then release SET.

4.Use the “Manufacturer’s Codes (Códigos del Fabricante)” (starting on page 42) to locate the type of device

OWNER’S MANUAL

and brand name and then enter the first four-digit code for your device. If performed correctly, the LED will blink twice.

NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter the same code again.

5.Aim the remote control at the device and press POWER once. The device should turn off. If it does not, repeat steps 2 through 5, trying each code for your brand until you find one that works. If it still doesn’t work, try “Searching for Your Code” on page 8.

NOTE: If the device does not have a POWER

key, press the (PLAY) key.

6.Repeat steps 1 through 5 for each device you want to control. For future reference, write down each working device code in the following boxes:

TV Code:

Brand Name:_____________________

VCR Code:

Brand Name:_____________________

PVR Code:

Brand Name:_____________________

CBL/SAT Code:

Brand Name:_____________________

DVD Code:

Setting Up Your Components 7