One for All 6-Device Universal Remote owner manual Using Keymover

OFA 6L with Learning Owners Manual.fm Page 14 Thursday, February 17, 2005 1:10 PM

ONE FOR ALL 6L UNIVERSAL REMOTE CONTROL WITH LEARNING

VCR as 2nd	SET - 9 - 9 - 2 - TV -
TV key:	VCR
VCR as 2nd	SET - 9 - 9 - 2 -
CBL/SAT key:	CBL/SAT - VCR
VCR as 2nd	SET - 9 - 9 - 2 - PVR -
PVR key:	VCR
VCR as 2nd	SET - 9 - 9 - 2 - AUD -
AUD key:	VCR

You can also re-assign another unused device key by substituting an open key for the VCR key in the above chart and performing the sequence. For example, to re-assign an unused CBL/SAT key as a 2nd TV key, perform SET - 9 - 9 - 2 - TV - CBL/SAT. When a re-assignment is done, the LED (red light) will blink twice to confirm your choice. At that time, you will need to program the remote control for the new device (see “Setting Up Your Components” on page 7).

USING KEYMOVER

The One For All 6L Universal Remote Control with Learning (URC-6820 B00) includes a Keymover feature that allows you to map (or copy) keys from one mode (i.e., source mode) to another mode (i.e., destination mode).

NOTE: The following keys cannot be used as a

source or destination: TV, CBL/SAT, VCR, DVD, PVR, AUD, FAV, and SET.

PROGRAMMING KEYMOVER

For example, if your VCR does not have volume control, you can map those keys (i.e., VOL +, VOL -, and MUTE) from the TV mode to the VCR mode as follows:

1.Press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 9 4. The LED will blink twice.

3.For the source mode, press TV once.

4.For the source key, press VOL + once.

5.For the destination mode, press VCR once.

6.For the destination key, press VOL + once.

7.The LED will blink twice, indicating the keymoved sequence is correct.

8.Repeat steps 1 through 7 twice more to map remaining volume control keys, substituting VOL - and MUTE as source and destination keys in steps 4 and 6.

Upon completion of the above procedure, you can now use your One For All 6L Universal Remote Control with Learning (URC-6820 B00) to control the TV’s volume and MUTE in the VCR mode, as well as in the TV mode.

RESTORING KEYMOVED KEYS TO DEFAULT SETTINGS

Restoring a Single Keymoved Key

1.Press a device key that has a keymoved key.

2.Press and hold SET until the LED (red light) blinks twice, then release SET.

3.Enter 9 9 4. The LED will blink twice.

4.Press the destination key twice (where the keymoved key is stored). The LED will blink twice.

Restoring All Keymoved Keys in a Single Mode

1.Press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 9 4. The LED will blink twice.

3.Press the destination mode twice (where keymoved keys are stored). The LED will blink twice.

14 Using Keymover