One for All 6-Device Universal Remote owner manual Changing Volume Lock, Unlock

OFA 6L with Learning Owners Manual.fm Page 15 Thursday, February 17, 2005 1:10 PM

CHANGING VOLUME LOCK

The One For All 6L Universal Remote Control with Learning (URC-6820 B00) is set at the factory for independent volume control of each selected device.

However, you may change the Volume Lock setting to Global Volume Lock so that a device’s volume will be locked to one mode (e.g., to control TV volume in all other modes). After that, if desired, you can perform Individual Volume Unlock on a selected device to set its volume control for independent operation.

LOCKING VOLUME CONTROL TO ONE MODE (GLOBAL VOLUME LOCK)

1.Press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 9 3 and then press any mode key once (e.g., TV). The LED will blink twice.

3.Now, when you press VOL +, VOL -, or MUTE, the volume of the selected device (e.g., TV) will be controlled regardless of the mode you have selected.

UNLOCKING VOLUME CONTROL FOR A

SINGLE DEVICE (INDIVIDUAL VOLUME

UNLOCK)

1.After performing Global Volume Lock (see left), press a desired mode key where you want volume to be unlocked (e.g., AUD) and controlled within its own mode.

2.Press and hold SET until the LED (red light) blinks twice, then release SET.

3.Enter 9 9 3 and then press VOL - once. The LED will blink four times.

OWNER’S MANUAL

4.If desired, repeat steps 1 through 3 (of this section) for each device that you want volume to be unlocked.

5.Now, after you select a device that has volume unlocked (e.g., AUD), pressing

VOL +, VOL -, or MUTE, will control the device’s volume only in its own mode.

UNLOCKING ALL VOLUME CONTROL (RESTORING DEFAULT SETTING)

NOTE: Performing these instructions will restore independent volume control for all programmed devices (e.g., TV volume control in TV mode, VCR volume in VCR mode, etc.).

1.On the remote control, press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 9 3 and then press VOL + once. The LED will blink four times.

3.Volume will again be independently controlled according to its default states for all programmed devices.

RESTORING FACTORY DEFAULT SETTINGS

The One For All 6L Universal Remote Control with Learning (URC-6820 B00) includes a Setup Code Reset program. You can use it to restore all your programmed codes to factory settings and delete all custom programming.

IMPORTANT: Executing this program erases all code settings and all custom settings including, Macros, Learned Keys, Reassigned Device Keys, Keymoved Keys, Favorite Channels, and all device settings.

Changing Volume Lock 15