One for All URC-7540 manual Trouble-Shooting, Helpful Hints, Problem Solution

Trouble-Shooting

Helpful Hints

Problem:	Solution:
Red light does not blink	Replace batteries with 2 fresh,
when you press a key?	new “AA” alkaline batteries.
The ONE FOR ALL does	Make sure you are using new
not respond after	batteries and are aiming the at
pressing a key?	your device.
The ONE FOR ALL does	A) Try all the codes listed for
not operate your	your brand. B) Try the search
device(s)?	method on page 8.
Your brand is not listed	Try the search method on page
in the code section?	8.
The ONE FOR ALL is not	You may be using the wrong
performing commands	code. Try repeating the Direct
properly?	Set-Up using another code
	listed under your brand or start
	the search method over again
	to locate the proper code.
Press a key but get the	Hold MAGIC until the red light
wrong result?	blinks twice, then press 992
	and the device key twice. You
	will need to set-up your device
	again. Try the codes for brand
	or the search method on page 8.
Problems changing	Enter the programme number
channels?	exactly as you would on your
	original remote.
You cannot control the	Hold MAGIC until the red light
volume feature of your	blinks twice. Then press 993
Satellite, Cable	then Vol+. To set the Volume
Converter or TV/Video	back to TV (Punch-Through),
Combination unit.	hold the MAGIC until the red
	light blinks twice, then press
	993 TV.
Video not recording?	As a safety feature on your ONE
	FOR ALL, you must press the
	Record key twice.
You’re having problems	The ONE FOR ALL may just
operating all the	need customising for your
functions of your device	model type. Just call our
	consumer help-line and we’ll
	get you on the right track.

30