Onkyo CR-505 Connecting Your Speakers, Strip 10 mm from the, end of each cord, Push the lever up

Connecting Your Speakers

Before you connect your speakers, read the following:

•Disconnect the power cord from the wall outlet.

•Read the instructions supplied with your speakers.

•Pay close attention to speaker wiring polarity. In other words, connect positive (+) terminals only to positive (+) terminals, and negative (–) terminals only to negative (–) terminals. If you get them the wrong way around, the sound will be out of phase and will sound odd.

•Only use speakers with an impedance of 4 ohms or higher. If you use speakers with a lower impedance, and use the amplifier at high volume levels for a long period of time, the built-in protection circuit may be activated.

•Unnecessarily long or very thin speaker cables may affect the sound quality and should be avoided.

•Be careful not to short the posi-

tive and negative connections. NO

Doing so may damage the CD

Receiver.

•Don’t connect more than one

cable to each speaker terminal. Doing so may damage the CD Receiver.

•If you want to connect a single speaker instead of a pair, connect it to either the left or right speaker terminals, not both.

NO	NO
SPEAKERS	SPEAKERS
RL	RL

Connecting the Speaker Cords to the Speaker Connectors

1 Strip 10 mm from the

end of each cord. 10 mm (7/16“)

2 Twist the stripped end of the cord.

3 Push the lever up.

4 Insert the stripped end of the cord.

5 Press down the lever. The wire of the stripped end of the cord should appear slightly.

.

Powered

subwoofer

LINE INPUT

SUB

WOOFER

PRE OUT

REMOTE CONTROL

AM

L

IN IN IN

R

ANTENNA

OPTICAL

DIGITAL

OUT

FM 75

	R	SPEAKERS
SUB		L
WOOFER
PRE OUT

R	SPEAKERS
	L

TAPE MD LINE

L

OUT OUT

R

The SUBWOOFER PRE OUT should be connected to the input on your powered subwoofer. If your subwoofer doesn’t have an amp built-in, you’ll need to use an exter- nal amp. See the manual supplied with your subwoofer for more information.

Right Left speaker speaker

11