Onkyo CR-505 The timer didn’t work?, No sound is output when a, timed playback or record

Troubleshooting—Continued

	Trouble		Possible Cause		Remedy
		The CR-505 was already on at the specified		Set the CR-505 to Standby (page 29). The
				CR-505 must be in Standby mode, otherwise
		ON time.
				the timed task will not work.
		The	-connected cassette tape deck or	You must set the recording devices to standby
The timer didn’t work?		MD recorder had not been in standby mode.		mode too.
		The specified ON time coincided, or over-		Check the timer settings and correct as neces-
		lapped the ON time of another timer.		sary (page 30).
		The CR-505 is only connected digitally to		To make recordings with		-connected MD
				recorder, connect the recorder’s analog inputs
		the MD recorder.
				to the CR-505’s analog outputs.
		While a timed recording task is in progress,		To hear what’s being recorded, press the
No sound is output when a				[MUTING] button to cancel the Mute func-
		the output of the CR-505 is muted.
timed playback or record-				tion. Press it again to mute the CR-505.
ing task starts?		For timed playback, the volume is deter-		Set the volume to a suitable level (page 19).
		mined by the [VOLUME] control.
		There’s no RCA/phono analog audio con-		To use	you must make an analog audio
	doesn’t work.			connection (RCA/phono) between CR-505
		nection.		and your Onkyo components even if they are
				connected digitally.
Standby indicator flashes.		The protection circuit may be activated.		Make sure not to short-circuit the positive and
				negative speaker wires.

Abnormal Behavior

The CR-505 contains a microcomputer for signal processing and control functions. In very rare situations, severe interfer- ence, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Restoring the Default Settings

To reset the CR-505 to its factory defaults, turn it off and unplug the power cord. Then press and hold the [STANDBY/ON] button on the CR-505, and plug in the power cord.

35