Powering Up and Setting the
■Setting ACCUCLOCK to Use a Specific
Station
If the wrong time is displayed, you can specify which FM station the ACCUCLOCK function should use. This must be an FM station that supports RDS CT (Clock Time) infor- mation.
1 Use the [INPUT] button to select FM.
2 Press the [TIMER] button repeatedly until “CLOCK” appears.
3 Press the [ENTER] button.
“ACCUCLOCK” appears on the display.
If “MANUAL ADJ” appears, use the Up/Down [
]/ [ ] buttons to select “ACCUCLOCK.”
4 Press the [ENTER] button.
“AUTO” appears on the display.
5 Use the Up/Down [
]/[ ] buttons to select “STATION” and press [ENTER].
6 Use the [
]/[ ] buttons to tune into the FM station.
The RDS indicator appears when tuned into a station that supports RDS.
RDS indicator
RDS
7 Press the [ENTER] button.
While the clock is being set, “WAIT” appears on the display. It may take a few minutes to set the clock. When the clock has been set, “ADJUSTED” appears on the display for a while.
Notes:
•If the clock has not been set correctly, specify another FM station and try again, or set the clock manually (see page 18).
•If you don’t want the clock to be calibrated automatically, you can turn off the ACCUCLOCK function (see the next section).
■Turning Off ACCUCLOCK
If you don’t want ACCUCLOCK to calibrate the clock auto- matically at 2 AM, 3 AM and 2 PM everyday, you can turn it off as follows.
1 Use the [INPUT] button to select FM.
2 Press the [TIMER] button repeatedly until “CLOCK” appears on the display, as shown.
3 Press the [ENTER] button.
“ACCUCLOCK” appears on the display.
4 Use the Up/Down [
]/[ ] buttons to select “MANUAL ADJ.”
5 Press the [ENTER] button 3 times.
17
