Onkyo DV-SP1000E Controlling Other Components, Entering Remote Control Codes, page, Notes

Controlling Other Components

In addition to controlling the DV-SP1000/DV-SP1000E, the remote controller can also be used to control your TV and VCR. To do this you need to enter the appropriate control codes for your TV and VCR. The remote control- ler can also learn individual commands from another remote controller (see page 91).

							Tx/Learn
STANDBY	ON	STANDBY				TV	indicator
					I	INPUT
	1			2	3	+
Number						TV CH
	4			5	6	-
buttons	7			8	9
						TV VOL
	+10			0	CLEAR
SEARCH		MEMORY			DIMMER AMP INPUT
	S			M	D	INPUT
				AMP INPUT
	DVD			V1	V2	V3	TV
				MODE
	DVD		AMP		VCR	TV
						PICTURE	VCR
ZOOM ON						CONTROL
				ENU	M
AUDIO			PM		EN
		TO			U
SEL
	+
	CH
ZOOM				ENTER		VOL
L MODE
	-
		RE		TURN	UP
					SET
DISPLAY						MUTING
LAST MEMORY				STEP/SLOW		RANDOM
REC	LM					RD
	AUDIO	SUBTITLE			ANGLE	RESOLUTION
	AUDIO		SBTTL		ANGLE	RSLTN
REPEAT				A-B		ASPECT
	REPEAT			A-B		ASPECT
VIDEO INPUT			VIDEO OFF		LEARNING
	V IN		V OFF		L1	L 2
OPEN/CLOSE
					L 3	L 4
				RC-563DV

3			Use the number buttons to enter
			the 4-digit remote control code.
Remote controller			If the code is accepted, the Tx/
1	2	3	Learn indicator flashes slowly
4	5	6	twice.
7	8	9	If the Tx/Learn indicator flashes
			quickly three times, the code has not
+10	0
			been accepted, in which case you

should try again from step 2.

Notes:

•The learning mode will be cancelled if you don’t press any buttons for 30 seconds.

•In some cases, not all of the remote controller’s but- tons may work as expected.

•Individually learnt commands for the TV and VCR modes (see page 91) are deleted when a new remote control code is entered.

Entering Remote Control Codes

Entering the appropriate remote control code for your TV and VCR will allow you to control them with the DV-SP1000/DV-SP1000E’s remote controller. You’ll need to perform this procedure twice to enter the codes for both your TV and VCR.

1	Look up the appropriate remote
	control code for your TV or VCR.
	See “Remote Control Codes” on
	page 87

2

Remote controller

MODE

VCR TV

While holding down the [VCR] or [TV] MODE button, press the [STANDBY] button, and then release both buttons.

The Tx/Learn indicator flashes slowly once, and then remains lit.

STANDBY

86