Onkyo DV-SP1000E Setting Levels With the Test Tone, AV Synchronization, Use the Up and Down, menu

Configuring the DV-SP1000/DV-SP1000E—Continued

Setting Levels With the Test Tone

1	Use the Up and Down [ ]/[ ]
Remote controller	buttons to select Test Tone, and
	then press the [ENTER] button.
	The Test Tone settings appear onscreen.
ENTER

AV Synchronization

When using progressive scanning you may find that the picture and sound are out of sync. With this setting you can delay the audio to correct this. There are three setup memories (1, 2, 3) for storing settings for up to three components. Memories 2 and 3 are already set at 50 ms, which is a good staring point when compensating for the video delay caused by a typical projector with a built-in scaler.

2

Remote controller

ENTER

Use the Up and Down []/[ ] buttons to select each speaker, press the [ENTER] button, use the Left and Right []/[ ] but- tons to adjust the levels, and then press the [ENTER] button.

A test tone is output by each speaker as it is selected.

Speaker levels can be adjusted in 1 dB steps.

	ON	STANDBY			TV
					I	INPUT
	1			2	3	+
						TV CH
	4			5	6	-
	7			8	9
						TV VOL
	+10			0	CLEAR
	SEARCH	MEMORY			DIMMER	AMP INPUT
	S			M	D	INPUT
				AMP INPUT
	DVD			V1	V2	V3
				MODE
	DVD		AMP		VCR	TV
						PICTURE
	ZOOM ON					CONTROL
ENTER				ENU	M
	AUDIO		PM		EN
		TO			U
	SEL
	+
	CH
	ZOOM			ENTER		VOL
	L MODE
	-
		RE		TURN	UP		SETUP
					SET
	DISPLAY					MUTING
	LAST MEMORY			STEP/SLOW		RANDOM
	REC LM					RD
	AUDIO	SUBTITLE			ANGLE	RESOLUTION
	AUDIO		SBTTL		ANGLE	RSLTN
	REPEAT			A-B		ASPECT
	REPEAT			A-B		ASPECT
	VIDEO INPUT		VIDEO OFF		LEARNING
	V IN		V OFF		L1	L 2
	OPEN/CLOSE

Speaker	Range	Default
Front Left
Center
Front Right	–12 dB to
		0 dB
Surround
	0 dB
Right
Surround Left
Subwoofer
You cannot set the level of speakers that
are set to Off.

3	When you’ve finished, press the
	[SETUP] button to exit setup, or

Remote controller press the Left [] button repeat-

SETUP	edly to go back to the main setup
	menu.

L 3	L 4
RC-563DV

Selecting the AV Synchronization

1 Use the Up and Down []/[ ] buttons to select setup 1, 2, or 3, and then press the [ENTER] or Right [ ] button.

The parameters appear onscreen.

79