Onkyo HT-R640 instruction manual 2-10, Speaker Configuration, First Time Setup-Continued

First Time Setup—Continued

Speaker Configuration 2

With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. The following crossover frequencies can be specified:

Full Band, 40 Hz, 50 Hz, 60 Hz, 80 Hz, 100 Hz, 120 Hz, 150 Hz, 200 Hz.

Specify Full Band for speakers that can output low-fre- quency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover fre- quency will be output by the subwoofer instead of the speaker. Refer to your speakers’ manuals to determine the optimum crossover frequencies.

3

Use the Up and Down []/[ ] buttons to select “1. Speaker Config,” and then press [ENTER].

The Speaker Config menu appears.

1.Speaker Config

------------------------

a.Subwoofer		:Yes
b.Front	:	100Hz
c.Center	:	100Hz
d.Surround :		100Hz
e.LPFofLFE :		120Hz
f.DoubleBass		:---

Use the Up and Down []/[ ] buttons to select “a. Subwoofer,” and then use the Left and Right

1

2

STANDBY/ON

REMOTE MODE

		RECEIVER	DVD
	TAPE/AMP
INPUT SELECTOR			M D/CDR
1	2	3	CD
			HDD
V1	V2	V3
4	5	6	T V
V4	MULTI CH	DVD
7	8	9	VCR
TAPE	TUNER	CD	CABLE
10	11	12
+10	0	CLR	SAT
D TUN	ENT
--/---	DIMMER	SLEEP
TV	VOL	CH	VOL
		DISC
		ALBUM
INPUT
GUIDE			PREVIOUS
TOP MENU			MENU

MUTING

ENTER

PLAYLIST/CATPLAYLIST/CAT

RETURN SETUP

4

2-10
1, 11	5

[]/[ ] buttons to select:

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

Use the Up and Down []/[ ] buttons to select “b. Front,” and then use the Left and Right []/ [ ] buttons to select a crossover frequency.

Note:

If the Subwoofer setting in step 3 is set to No, this setting is fixed at Full Band.

Use the Up and Down []/[ ]

1		Press the [RECEIVER] or [AMP]
		button followed by the [SETUP]
AMP	RECEIVER	button.
		The main menu appears onscreen.

SETUP

buttons to select “c. Center,” and then use the Left and Right []/ [ ] buttons to select a crossover frequency.

If no center speaker is connected, select None.

Note:

If the Front setting in step 4 is set to anything other than Full Band, Full Band cannot be selected here.

42