Onkyo HT-R640 Using the Sleep Timer, Setting the Display Brightness, Using Headphones

Basic Operations—Continued

STANDBY/ON REMOTE MODE

RECEIVER	DVD
TAPEAMP
INPUT SELECTOR	M D/CDR

Press [RECEIVER] or [AMP] first

Using the Sleep Timer

With the sleep timer, you can set the AV receiver to turn off automatically after a specified period.

DIMMER

1	2	3	CD
			HDD
V1	V2	V3
4	5	6	T V
V4	MULTI CH	DVD
7	8	9	VCR

TAPE	TUNER	CD	CABLE
10	11	12
+10	0	CLR	SAT
D TUN	ENT
--/---	DIMMER	SLEEP

TV VOL	CH	VOL
	DISC
	ALBUM
INPUT
GUIDE		PREVIOUS
TOP MENU		MENU

MUTING

ENTER

PLAYLIST/CATPLAYLIST/CAT

SLEEP

MUTING

AMP RECEIVER

SLEEP

Press the [RECEIVER] or [AMP] button, and then press the [SLEEP] button repeatedly to select the required sleep time.

The sleep time can be set from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator appears on the display when the sleep timer has been set. The specified sleep time appears on the display for about five seconds, then the previous display reappears.

Setting the Display Brightness

You can adjust the brightness of the display.

If you need to cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears.

To check the time remaining until the AV receiver sleeps, press the [SLEEP] button. Note that if you press the

AMP RECEIVER

Press the [RECEIVER] or [AMP]

[SLEEP] button while the sleep time is being displayed,

DIMMER

button, and then press the [DIM- MER] button repeatedly to select:

•Normal+VOLUME light on.

•Normal+VOLUME light off.

• Dim+VOLUME light off.

• Dimmer+VOLUME light off.

you’ll shorten the sleep time by 10 minutes.

Using Headphones

You can connect a pair of stereo headphones (1/4-inch phone plug) to the AV receiver’s PHONES jack for pri- vate listening, as shown.

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.

AMP RECEIVER

MUTING

Press the [RECEIVER] or [AMP] button, and then press the [MUT- ING] button.

The output is muted and the MUTING indicator flashes on the display, as shown.

To unmute the AV receiver, press the [MUTING] button again, or adjust the volume.

The Mute function is cancelled when the AV receiver is set to Standby.

Notes:

•Always turn down the volume before connecting your headphones.

•The speakers are turned off while the headphones plug is inserted in the PHONES jack.

•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio (not North American models).

•Only the Stereo, Direct, Pure Audio (not North Amer- ican models), and Mono listening modes can be used with headphones (the listening modes available also depend on the currently selected input source).

•When the multichannel input is used, only the front left and right audio can be heard in the headphones.

•To adjust the headphone level, press the [CH SEL] button on the remote controller, and then press the [LEVEL +]/[LEVEL -] buttons. You can adjust the level between –12 dB and +12 dB.

47