Onkyo HT-R640 instruction manual IntelliVolume, Volume Setup/OSD Setup, Miscellaneous Setup

Advanced Setup—Continued

IntelliVolume

You can set the input level for each input source. This is useful if some of your AV components are louder or qui- eter than others.

While this menu is shown onscreen, you can select each input source and set the levels while listening to and comparing them.

1	Press the [RECEIVER] or [AMP]
	button followed by the [SETUP]
AMP RECEIVER	button.
	The main menu appears onscreen.

SETUP

2			Use the Up and Down [ ]/[ ]
			buttons to select “5. Input
			Setup,” and then press [ENTER].
			The Input Setup menu appears.
			5.Input Setup
			--------DVD/MCH---------
			a.IntelliVolume: 0dB
			Listening Mode Preset
			b.Ana/PCM:Last Valid
			c.Dolby D:Last Valid
			d.DTS	:Last Valid
			e.D.F.2ch:Last Valid
			f.Mono	:Last Valid
			g.MCH Ana:Last Valid
3			Use the INPUT SELECTOR but-
1	2	3	tons on the remote controller to
			select the input source that you
V1	V2	V3
4		6	want to set.
V4		DVD
7	8	9
TAPE	TUNER	CD

4 Use the Up and Down []/[ ]

buttons to select “a. IntelliVolume.”

If a component is too loud compared to your other components, use the Left

[] button to adjust the level. If it’s too quiet, use the Right [ ] button.

•The level can be set from –12 dB to +12 dB.

Volume Setup/OSD Setup

This section explains the items on the Miscellaneous Setup menu.

1	Press the [RECEIVER] or [AMP]
	button followed by the [SETUP]
AMP RECEIVER	button.
	The main menu appears onscreen.

SETUP

2	Use the Up and Down [ ]/[ ]
	buttons to select
	“6. Miscellaneous Setup,” and
	then press [ENTER].
	The Miscellaneous Setup menu
	appears.
	6.Miscellaneous Setup
	------------------------
	a.MaximumVolume: Off
	b.PowerOnVolume: Last
	c.Immediate Display
	:Normal

3	Use the Up and Down [ ]/[	]
	buttons to select the settings,
	and use the Left and Right [	]/

[ ] buttons to set them.

The settings are explained on page 69.

4	When you’ve finished, press the
	[SETUP] button.
	The setup menu closes.
SETUP

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

68