Onkyo HT-RC430 En-18, Connecting the Antennas, Connecting the Power Cord, Connections

Models: HT-RC430

1 64
Download 64 pages 5.07 Kb
Page 18
Image 18
Connecting the Antennas

Connecting the Antennas

This section explains how to connect the supplied indoor FM antenna and AM loop antenna.

The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use the tuner.

Push. Insert wire. Release.Insert the plug fully into the jack.

Assembling the AM loop antenna

Caution

Assembling the AM loop antennaConnecting the Power CordEn-18Manual backgroundManual backgroundManual background • Be careful not to injure yourself when Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background using thumbtacks.

Thumbtacks, etc.

AM loop antenna (supplied)

Indoor FM antenna (supplied)

Note

Once your AV receiver is ready for use, you’ll need to tune into a radio station and position the antenna to achieve the best possible reception.

Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.

Tip

If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.

If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM antenna.

Connections

Connecting the Power Cord

1 Plug the power cord into an AC wall outlet.

Note

Before connecting the power cord, connect all of your speakers and AV components.

Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

En-18

Page 18
Image 18
Onkyo HT-RC430 En-18, Connecting the Antennas, Connecting the Power Cord, Assembling the AM loop antenna, Connections