Onkyo HT-S5200 instruction manual Connecting Speaker Set a, Connecting Speaker Set B

Connecting the AV receiver—Continued

Connecting Speaker Set A

1	Strip 1/2"-5/8" (12-15	1/2"-5/8"(12-15mm)
	mm) of insulation from the
	ends of the speaker cables.
	(Supplied speaker cables
	are already stripped.)
2	Unscrew the terminal. Fully insert the bare wire,
	making sure that it’s touching the threaded shaft

in the center. Screw the terminal tight.

Connecting Speaker Set B

1	Strip 3/8"-1/2" (10-12	3/8"-1/2"(10-12mm)
	mm) of insulation from the
	ends of the speaker cables,
	and twist the bare wires
	tightly, as shown.
2	While pressing the lever, insert

the wire into the hole, and then release the lever.

Make sure that the terminals are gripping the bare wires, not the insulation.

Note:

While speaker set B is on, speaker set A is reduced to 5.1-channel playback.

The following illustration shows which speaker should be connected to each pair of terminals.

If you’re using only one surround back speaker, connect it to the left (L) SURR BACK SPEAKERS terminals.

	Speaker Set A
Front right	Front left
speaker	speaker
	Center
	speaker

Front right	Front left
speaker	speaker

Speaker Set B

Powered	Surround	Surround	Surround	Surround
subwoofer	back right	back left	right	left
	speaker	speaker	speaker	speaker

20