Onkyo HT-S5200 instruction manual Video Attenuation, Video ATT0 default

Troubleshooting—Continued

The following settings can be made for the composite video inputs

You must use the buttons on the unit to make these settings.

1.While holding down the input selector button for the input source that you want to set, press the [SETUP] button.

2.Use the Left and Right [e]/[r] buttons to change the setting.

3.Press the [SETUP] button when you’ve finished.

• Video Attenuation

This setting can be made for the DVD/BD, VCR/DVR, CBL/SAT, or AUX input.

If you have a games console connected to the composite video input, and the picture isn’t very clear, you can attenuate the gain.

Video ATT:0: (default).

Video ATT:2: Gain is reduced by 2 dB.

The AV receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least 5 seconds, and then plug it back in again.

Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by this unit’s malfunction. Before you record important data, make sure that the material will be recorded correctly.

Before disconnecting the power cord from the wall outlet, set the AV receiver to Standby.

87