Onkyo TX-8522, TX-8222 Connecting Your Speakers—Continued, Press the SETUP button on the, setting

TX-85228222_En.book 13 ページ ２００６年５月４日 木曜日 午前１１時５１分

Connecting Your Speakers—Continued

Configuring the Speaker Impedance (TX-8522 North American model only)

In this model, the factory default for speaker impedance is “8 ohms.” When you change the speaker impedance setting, read “Speaker Connection Precautions” on page 12 carefully before performing the procedures below.

Note:	4	Press the SETUP button on the
Be sure to minimize the volume level on the receiver
		remote controller to complete the
before configuring the speaker impedance.
		setting.
		When you restore the impedance
1		setting to 8 ohms, use the same
		procedures above.

2, 4

SETUP

3

1

2

3

Turn on the power.

Press the SETUP button on the remote controller.

The “Impedance: 8 ohms” indication appears in the display.

Change the impedance value to “6 ohms” using the []/[ ] buttons.

13