Theater-Dimensional Setting
■Listening Angle
`Wide:
Select if the listening angle is 40 degrees.
`Narrow:
Select if the listening angle is 20 degrees.
With this setting, you can optimize the
Front left speaker | Front right speaker |
| 20°/40° |
Name Edit
Menu | Name Edit |
You can enter a preset name for each individual input selector for easy identification. When entered, the preset name will appear on the display.
Preparation
Press the input selector buttons to select an input source.
■Name
`- -
To reset to the default, select “- -
Note
•Can not set the input selector by the same name.
•This menu cannot be used for the TUNER input selector.
Hardware
Menu | Hardware |
Speaker Settings
If you change these settings, you must run Audyssey 2EQ® Room Correction and Speaker Setup again (➔ 23).
If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms. If you
For hookup information, see
En
Note
•When
•Before you change these settings, turn down the volume.
■Sp Impedance
`4ohms:
Select if the impedance of any speaker is 4 ohms or more but less than 6.
`6ohms:
Select if the impedances of all speakers are between 6 and 16 ohms.
Note
•(North American models) Do not support speakers with an impedance of less than 6 ohms.
■Speakers Type
`Normal:
Select this if you’ve connected your front speakers normally.
`
Select this if you’ve
■Front High/Zone2
`Front High:
Front high speakers can be used.
`Zone2:
Zone2 speakers can be used.
Select “Zone2” if you’ve connected your Zone 2 speakers
to FRONT HIGH OR ZONE 2 SPEAKERS L/R termi-
nals (➔ 46).
Note
•If the “Speakers Type” setting is set to
■SurrBk/FrontHigh
`Front High:
Front high speakers can be used.
`SurrBack:
Surround back speakers can be used.
Select “Front High” if you’ve connected your Zone 2 speakers to FRONT HIGH OR ZONE 2 SPEAKERS L/ R terminals, and the front high speakers to SURR BACK OR FRONT HIGH SPEAKERS L/R terminals.
Note
•If the “Front High/Zone2” setting is set to “Front High”, this setting is set to “SurrBack”.
•If the “Speakers Type” setting is set to
40