If you want to control an Onkyo component by pointing the remote controller directly at it, use the following remote control codes:
`32900:
Onkyo
`32901:
Onkyo
`70868:
Onkyo MD recorder
`71323:
Onkyo CD recorder
`82990: Onkyo Dock
Note
•If you connect an cassette tape deck to the TV/CD IN jack, or connect an RI Dock to the TV/CD IN or VCR/DVR IN or GAME IN jacks, for uto work properly, you must set the Input Display accordingly (➔ 22).
Resetting REMOTE MODE Buttons
You can reset a REMOTE MODE to its default remote control code.
1 While holding down REMOTE MODE that you want to reset, press and hold down AUDIO until the remote indicator lights (about 3 seconds).
2 Within 30 seconds, press REMOTE MODE again.
The remote indicator flashes twice, indicating that the button has been reset.
Each of REMOTE MODE is preprogrammed with a remote control code. When a button is reset, its pre- programmed code is restored.
Resetting the Remote Controller
You can reset the remote controller to its default settings.
1 While holding down RECEIVER, press and hold down AUDIO until the remote indicator lights (about 3 seconds).
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the remote controller has been reset.
Controlling Other Components
By pressing REMOTE MODE that’s been programmed with the remote control code for your component, you can control your component as below.
For details on entering a remote control code for a differ- ent component (➔ 53).
Controlling a TV
TV is preprogrammed with the remote control code for controlling a TV that supports the p*1. The TV must be able to receive remote control commands via
pand be connected to the AV receiver via HDMI. If controlling your TV via pdoesn’t work very well, program your TV’s remote control code into TV and use the TV remote mode to control your TV.
Controlling a
BD/DVD is preprogrammed with the remote control code for controlling an Onkyo
En
54
