JVC CA-MXDVA9 manual Using Recording Timer, Select the preset station, If necessary

Continued

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the system is on or off.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “VOL MIN,” and starts recording when the on-time comes (the indicator continues flashing while the timer is operating). Then, when the off-time comes (“OFF” flashes just before the off-time), the unit automatically turns off (on standby).

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

•To correct a misentry while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER repeatedly until “REC” appears on the display.

indicator lights up and the REC (Recording Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

(Daily timer setting)

Canceled		Clock	ON TIME
		setting	(Recording
	(The hour digits		timer setting)
	start flashing.)

3 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds on the display, then the unit enters on-time setting mode.

4 Set the on-time you want the unit to turn on at.

1)Turn 4 / ¢ to set the hour, then press SET.

2)Turn 4 / ¢ to set the minute, then press SET.

“OFF TIME” appears for 2 seconds on the display, then the unit enters

off-time setting mode.

5 Set the off-time you want the unit to turn off (on standby) at.

1)Turn 4 / ¢ to set the hour, then press SET.

2)Turn 4 / ¢ to set the minute, then press SET. The unit enters preset station selecting mode.

6 Select the preset station.

1)Turn 4 / ¢ to select the band (“TUNER FM” or “TUNER AM”), then press SET.

2)Turn 4 / ¢ to select a preset channel number, then press SET.

The REC (Recording Timer) indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence.

7 Press STANDBY/ON	to	STANDBY/ON
turn off the unit (on standby)		STANDBY
if necessary.

If you want to listen to another source while recording

Press REC START/STOP or 7 to stop recording. Without stopping it, you cannot change the source.

Even if you unplug the AC power cord or if a power failure occurs

Once you set the timer, the timer setting may remain stored in memory in a few days. In this case, check whether the timer setting still remains or not.

– 46 –