JVC CA-MXDVA9 manual Common Operations, Turning On or Off the Power, Setting the Clock

Common Operations

Turning On or Off the Power

To check the clock time

Press and hold SET while playing any source.

To turn on the unit, press

STANDBY/ON so that the STANDBY lamp goes off.

To turn off the unit (on standby), press

STANDBY/ON again so that the STANDBY lamp lights up.

STANDBY/ON

STANDBY

STANDBY/ON

STANDBY

• Pressing SET, the source indication appears again.

To adjust the clock again

If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

(Daily timer setting)

•A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away, while the tuner preset stations (see page 15) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

On the unit ONLY:

1 Press CLOCK/TIMER.

The hour digits start flashing on the display.

2 Turn 4 / ¢ to adjust the hour, then press SET.

The minute digits start flashing on the display.

• If you want to correct the hour after pressing SET, press

CANCEL/DEMO.

The hour digits start flashing again.

3 Turn 4 / ¢ to adjust the minute, then press SET.

Canceled		Clock	ON TIME
		setting	(Recording
	(The hour digits		timer setting)
	start flashing.)

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away. If this happens, set the clock again.

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

On the unit ONLY:

When shipped, the unit is set to 9 kHz spacing.

You can only change the AM tuner interval spacing while tuning into an AM station. (See page 15.)

Press STANDBY/ON while holding down 7.

• Each time you press these buttons, the

AM tuner interval spacing alternates	+
between 9 kHz and 10 kHz.
	STANDBY/ON

STANDBY

– 11 –