JVC CA-MXDVA9 manual Connecting Speakers, To connect an outdoor AM antenna

AM antenna

	ANTENNA	Vinyl-covered wire
		(not supplied)
1	AM EXT
	AM LOOP
	FM 75
	COAXIAL
2
	AM loop antenna
	(supplied)

1Connect the AM loop antenna to the AM

LOOP terminals as illustrated.

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Connecting Speakers

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

To connect main speakers and front subwoofers

1		3
	2
	Red
Speaker cords	FRONT	Speaker cords
(red/black)		(red/black)
	SUBWOOFERS
RIGHT	LEFT
Black		Black
RIGHT	LEFT
	MAIN
	SPEAKERS

CAUTION: SPEAKER IMPEDANCE

6 16

Blue

Speaker cords

(blue/black)

Right front speaker Left front speaker

•When using front multi speaker system, refer to

“Recommended Main Speakers and Subwoofers Layout” separately attached.

1Open the speaker terminal.

2Insert the end of the speaker cord into the

terminal.

Match the polarity (colors) of the speaker terminals: Red

(+)to red (+) and black (–) to black (–); Blue (+) to blue

(+)and black (–) to black (–).

3Close the speaker terminal.

– 7 –