I N S T A L L A T I O N

NOTE

Some TV sets do not support one or more HDMI output resolutions (particularly 1080p). In this case repeatedly press the HDMI button until a supported resolution is selected. Give your display a second or two to “grab on” to the new signal and attempt to display a picture.

In case you are not able to get a picture using the HDMI output, please connect the DVD player to the TV using either the composite video or S-Video output, and then use the setup menu to adjust the DVD player settings.

Set up Audio Options

Depending on your specific audio/video connection method, the audio options of the DVD player may need to be adjusted to match your configuration. Please refer to the video and audio connection methods described previously in this guide and the following audio setup guidelines.

Audio Connection Directly to TV

If your DVD player is connected directly to the TV through HDMI (as described in “Method 1” on page 8) or through DVI and analog L/R audio cables (as described in “Method 2” on page 9), it is recommended that you keep the factory default settings. The factory default settings set Speaker Setup Page > Down-mixto “Stereo”. In this mode the DVD player will mix the surround and center channels of multi-channel audio contents with the left and right front channels. Since most TVs only come with stereo speakers, this setup will ensure you hear all conversation and background audio from the DVD.

--- Speaker Setup Page ---

Down-mix

Stereo

Front Speaker

Large

Center Speaker

Small

Rear Speaker

Small

Subwoofer

Off

Channel Delay

 

Multi-Channel Digital Audio to Receiver through HDMI

If your DVD player is connected to an A/V receiver or processor with HDMI inputs for high resolution multi- channel digital audio, you are in luck! You are now equipped to send all current audio formats to your receiver in pure digital form. The connection method will typically be as described in “Method 3” on page 10 of this guide.

To get the best possible audio via HDMI, you may need to set the following options on the DVD player’s setup menu, depending on your HDMI-capable receiver configuration:

If your receiver supports HDMI 1.1 Multi-Channel PCM audio, most likely it also support DTS and/or Dolby Digital decoding and has surround speakers. Please set these DVD player options:

o Speaker Setup Page > Down-mix to “5.1 CH”

o Speaker Setup Page > Front Speaker to “Large” o Speaker Setup Page > Center Speaker to “Large” o Speaker Setup Page > Rear Speaker to “Large” o Speaker Setup Page > Subwoofer to “On”

18

Page 22
Image 22
OPPO Digital DV-987HD user manual Set up Audio Options, Audio Connection Directly to TV