ADVANCED OPERATIONS
TV System Selection
While you will want to set the video output system (NTSC/PAL) to the same as that supported by your TV, realize that the DVD player will convert,
Press the P/N button on the remote control to cycle the video output to PAL, NTSC or AUTO system. The TV screen displays the selected system name.
Some points to keep in mind:
•When the video output is set to PAL or NTSC system, the DVD player will convert the disc content to the selected system if it is different.
•When the video output is set to AUTO, the DVD player will not perform system conversion. The AUTO mode is only to be used if your TV supports both NTSC and PAL systems.
•Playback must be stopped before switching the system from one setting to another.
NOTE
•Some TV sets only support one of the NTSC or PAL systems. If the wrong output is selected, the TV may not display a picture. In this case repeatedly press the P/N button until a supported system is selected.
•The output system selection chosen with the P/N button will be reset when the DVD player is turned off. To permanently set the output system, please use the “TV Type” setup menu item in the “Preference” setup menu page. (Refer to page 45 for details.)
Fast Playback
You may fast forward or reverse to search for a certain point during playback.
1.Press the FWD button on the remote control and the player starts fast forward playback. Each press of the FWD button switches the playback speed in the following sequence:
2.Press the REV button on the remote control and the player starts fast reverse playback. Each press of the REV button switches the playback speed in the following sequence:
26
