OPPO Digital DV-987HD user manual Audio Setup

S E T U P M E N U O P T I O N S

Audio Setup Page

--- Audio Setup Page ---

Digital Output	Raw
LPCM Rate	48KHz
Audio Tone	00
Pro Logic II
Dolby Digital Setup
Channel Trim
Audio Delay	05
HDMI Audio	LPCM

1.Digital Output: To set the bit stream type of the digital audio output for use with Dolby Digital and DTS-compatible receivers. The options are:

•Raw – Passes the encoded multi-channel digital audio unaltered. Choose this setting if your receiver/amplifier is capable of decoding Dolby Digital and/or DTS.

•PCM – Forces down-mixed 2-channel digital audio output. Choose this setting if your receiver/amplifier only supports stereo digital (PCM) audio.

2.LPCM Rate: To set the maximum Linear PCM output frequency. The options are:

•48K – Supported by most equipment.

•96K – Allows a higher sampling rate and frequency response. It can result better audio quality. Ensure that the receiver/amplifier can support it.

•192K – Allows the highest sampling rate and frequency response. It can result the best audio quality. Ensure that the receiver/amplifier can support it.

Note: The LPCM rate is selectable only when HDMI Audio is turned off.

3.Audio Tone (+/-16): This function raises or lowers the tone (key/pitch) of the audio track. This is useful for playing Karaoke discs and should not be used for regular music listening or movies.

•Press the SELECT button to show the tone control window.

•Press the left/right ARROW buttons to lower or raise the tone/pitch.

•Press the SELECT button to confirm the setting.

4.Pro Logic II: Taking a step further than most DVD players, the OPPO DVD player allows you to configure Dolby Pro Logic II to expand 2-channel source audio into full 5-channel surround sound. Note: Pro Logic II functionality is effective only when Speaker Setup Page > Down- mix is set to “5.1ch” and Digital Output is set to “Raw”.

•Press the SELECT button to enter the “Pro Logic II Config” page.

•Press the left ARROW button to exit the “Pro Logic II Config” page.

A. Pro Logic II: To turn on or off the Pro Logic II processing. The options are:

40