4.Repeatedly press SEL 
or SEL 
to high- light VIDEO ADJUST.
USING LAST CHANNEL RECALL
5.Press SET. A screen appears with the cur- rent picture settings.
The TV/VCR’s last channel recall function lets you quickly switch between two channels you tuned.
Repeatedly press LCR (Last Channel Recall) on the remote control to switch between the chan- nel you are watching and the previous channel you tuned.
6.Repeatedly press SEL 
or SEL 
until the setting you want to adjust is highlighted, then press SET. A screen showing the cur- rently set adjustment for that setting appears.
Note: To reset all settings to their factory defaults, select NORMAL.
7.Repeatedly press SEL 
or SEL 
to adjust the picture as desired, then press
SET.
8.Repeat Steps 6 and 7 to adjust the other setting(s) as necessary.
9.Press MENU three times to exit this mode.
Note: If you do not press any button within 5 minutes, the picture setting screen disap- pears.
USING MUTE
To temporarily turn off the TV/VCR’s sound, press MUTE on the remote control. MUTE ap- pears on the TV screen.
To restore the sound to the previous level, press MUTE again. Or, to restore the sound and change its level, press VOL 
or VOL 
.
VIEWING AN EXTERNAL DEVICE
To view the signals from an external device con- nected to the audio/video input jacks on the back of the TV/VCR, do either of the following:
•Press MENU to display the main menu, repeatedly press SEL 
or SEL 
to select TV, then press SET. The SET UP TV screen appears. Then repeatedly press
SEL 
or SEL 
to highlight INPUT SELECT, press SET to select LINE, then press MENU twice. The menu disap- pears.
•Select one channel higher than the highest programmed channel or one channel lower than the lowest programmed channel.
LINE appears on the TV screen.
18
