The Concept of Statistics,” on page 16 of this Operator’s Manual.

Undo All Changes

Removes all settings made since last “DONE-- INSTALL CHANGES. Returns you to the Desk Accessory menu.

Done--Install Changes

Exits from the RamPak utilities and returns to ProDOS, while installing all of your memory settings in your IIGS RAM. Your RamPak Memory Management Utilities disk MUST be in the drive to install.

This Menu will open a Dialog Box entitled ‘Save Changes to Disk” which will allow you to select a memory- only installation or a Save-To-Disk. Save-to-Disk installs the changes on the disk so that they will be remembered at the next time you run your program. You will be prompted for the path name of the disk to which you wish to save the currrent changes. (Refer to theProDOS manual for instructions on how to do this.)

The Diagnostics Menu

Like any electronic component, RAM chips do have a potential to fail or to develop problems. If such occurrences go undetected, you may lose or corrupt your data. To help detect RAM problems before they cause damage, the RamPak Memory Management Utilities include two levels of testing, which can be executed either at the start of every session or on an “as- requested” basis.

Quick Memory Test

Selects a superficial READ-WRITE test of all installed RAM. Any errors will be detected and reported by address location. The QUICK MEMORY TEST is good for general use, as it takes considerably less time than the EXTENDED MEMORY TEST,yet is highly reliable in detecting the existence of a problem.

13