Oregon Scientific IB368 important safety instructions Recognizing Wireless Signals

1.Use a red-white-yellow audio cable and connect the red-white connectors to the line-in jacks of the output device. The yellow (composite video) connector does not need to be connected.

2.Plug the other end of the cable (stereo connector) to the transmitter dock line-out jack.

3.Use an S-Video cable and plug each end to the respective video output device and transmitter dock S-Video jacks.

4.From the iPod with color display, choose whether to view photos individually or as a slideshow and if the TV comes with speakers, select music to playback. The iPod with color display play / pause track and previous / next track or photo functions are adjusted directly from the player itself.

NOTE Controlling iPod functions from the iPod itself during a video connection does not influence what is shown on the speaker’s LCD.

TIP Under both video connection scenarios, the speaker can remain powered on and iPod music will playback. But if the speaker is operating on batteries, turn off the speaker to conserve power.

RECOGNIZING WIRELESS SIGNALS

The iBall speaker and transmitter dock is manufactured preset to automatically recognize each other wirelessly during operation through a process called “RF mating”.

However, there are certain occasions when signal jamming can occur, for example when a second iBall

within a 30-meter range (approx. 100 feet) is nearby whose radio frequency transmission signals jam with your iBall’s signals.

To eliminate signal jamming, follow the procedures below to set the RF mating function between the speaker and transmitter dock.

NOTE The entire RF mating process must be completed within 20 seconds in order for the speaker and transmitter dock to function properly, otherwise the process has likely timed out and will need to be restarted.

1.Disconnect all secondary audio sources or video output devices from the transmitter dock although you may choose to leave the iPod docked onto the transmitter dock.

2.Leave the AC adapter connected to the transmitter dock. If the adapter is not plugged in, connect it to the transmitter dock.

3.Designate the speaker to start the RF mating process. Plug in the speaker’s AC adapter if batteries are not used.

4.Power on the speaker and from its control panel,

press and hold both the and buttons for 3 seconds.

The LCD backlight on the iBall speaker turns off (the speaker itself remains on).

appears and blinks

during the RF mating process.

5.Press the RF mating button located at the bottom of the transmitter dock.

Once RF mating is successfully completed, the LCD backlight lights up with status icons appearing that indicate whether the iPod is docked onto the transmitter dock.

￿If iPod is not docked, appears.

￿If iPod is docked, appears.

14