6.

Slide the sleeve down to open the battery

 

compartment.

7.

Insert batteries (4 x UM-3 / AA) in the compartment,

10.Assemble the top pole to the mid-pole.

11.Use the screw to fi x.

EN

matching the polarity (+ / -) and press RESET

8. Slide the protective sleeve up to close the

compartment.

8

9

10

9. Rotate the sleeve to the right to lock.

5

7

8

 

 

 

 

 

 

 

 

 

 

 

 

6

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

9

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

To set up the steel pole support:

1.Assemble the “cone shape” guiding end with the bottom steel pole.

2.Screw the guiding end clockwise at the bottom of the pole.

3.Remove the cover hole from the plastic base.

1

3

2

4.Insert the plastic base onto the steel pole until the screw hole aligns with the support.

5.Use the screw that is already attached on the base, with the washers and bolts to fi x.

6.Use the guiding end to start inserting the steel pole at a perpendicular angle into the ground.

WARNING Make sure that there are NO electric cables / power lines, gas / water pipes in the area where you are placing the steel pole. Do not place the pole into a hard rocky type of ground as it may bend or break the pole. It should be inserted into soft soil.

7.Place a wooden block on the top of the pole. With a hammer, hit the wooden block to insert the pole at a perpendicular angle to the ground until reaching the base.

7

5

4

6

8.Assemble the mid-pole on top of the bottom pole.

9.Use the screw to fi x.

11

12.Assemble the wind sensor main body on top of the pole. Use the screw (Type A) to fi x.

13.Open the battery compartment.

14.Using a compass, rotate the wind direction part until the NORTH indicator points to the “North”.

15.Press RESET

16.Close the battery compartment.

13 14

1215

16

17.Insert the 2 rectangular base legs into the ground to

fi rmly fi x the pole.

18.To keep the pole stable, use the 3 pins to fi rmly fi x the tension strings to the ground.

17

18

To set up the wind sensor main body on an existing pole:

1.Remove the screw that fi xes the plastic connector at the end of the top pole.

2.Slide down the plastic connector.

3.Detach plastic base from the bundled steel pole if previously installed.

4.Assemble it at the end of the top pole using the screw that is already attached on the base, with the washers and bolts to fi x.

5