OTC Wireless switch/hub manual Start-up Steps, Enter the Vehicle Information

ABS / Air Bag 2004 User Guide	Chapter 2: Start-up Steps
	Introduction

13

2: Start-up Steps

Introduction

All vehicle setups require a specific cable connection to the vehicle Data Link Connector (DLC). To deter- mine the specific cable required for a vehicle, you must first enter the vehicle information. After you have done this, the screen displays the specific cable information for the vehicle. You then use this information to connect the correct cable to the DLC and proceed with the vehi- cle diagnostics.

This chapter includes the following general steps to get you started:

1Enter the vehicle information to determine the correct cable required.

2Connect the required cable.

3Select the diagnostic function you want to perform.

Figure 2.1: Application Manager Screen

2Select Scan Diagnostics and press the ENTER key. This displays the Scan Diagnostics screen.

Step 1: Enter the Vehicle

Information

Use the following steps to enter vehicle information and to determine which cable to use for the communication connection between the NGIS tool and the vehicle’s electronic control unit (ECU).

To enter the vehicle information, follow these steps:

Note: Before doing these steps, make sure the NGIS tool’s battery is charged.

1Press the NGIS tool’s power button to turn the tool on. This displays the Application Manager screen.

Figure 2.2: Scan Diagnostics Screen

3 Select ABS / Air Bag 2004 and press the ENTER key. This displays the first Vehicle Information screen (Figure 2.3 on page 14).