OTC Wireless switch/hub manual Enter the Vehicle Information

ABS / Air Bag 2004 User Guide	Chapter 2: Start-up Steps
	Step 1: Enter the Vehicle Information

15

6To reuse saved information for a vehicle already tested, do the following:

a Press the Reuse function key. This displays the Reuse Vehicles screen, which contains a list of saved vehicle descriptions.

Figure 2.5: Reuse Vehicles Screen

bSelect the vehicle description to use and press the ENTER key. This displays the illustration of the required cables, as shown in Step 6.

Note: The Reuse Vehicles list holds 25 vehicle descriptions. When the list is full, old descriptions automatically delete as you enter new descriptions. To prevent a description from being automatically deleted, highlight the description and press the Save function key. This places a disk icon to the left of the file name and saves the description until you delete it. (Use the Delete function key to delete a selected description.)

7After you have entered new vehicle information or selected a vehicle description to reuse, the Required Cables illustration displays on the Vehicle Identification screen. With this screen displayed, make the required cable connections. For specific steps, refer to the next section (“Step 2: Connect the Cable” on page 16).

Note: Some vehicles do not have an ECU and do not require a cable connection. For these vehicles, the screen states that no cable connection is required. If this happens, skip the next section and go to “Step 3: Select the Diagnostic Function” on page 18.

Figure 2.6: Vehicle Information - Required Cables Screen

Note: For some vehicles, this screen will illustrate the vehi- cle’s Data Link Connector (DLC) test terminals rather than the required cables.