OTC Wireless switch/hub manual Start-up Steps

ABS / Air Bag 2004 User Guide

Non-OBD II Vehicle Cable Connection

This type of connection generally requires the DB25 Power cable (3305-72) or another vehicle-specific cable.

Note: Some non-ODB II vehicles may require the System Smart 25-pin cable.

Note: For a description of the cables, refer to “Cables” on page 3.

To connect the DB25 Power cable or another similar cable, follow these steps:

Chapter 2: Start-up Steps

Step 2: Connect the Cable

2Connect the cable’s 25-pin connector to the DB25 port on the top of the NGIS tool. Finger tighten the connecting screws (see Figure 2.11).

Note: Extension cable (3305-71) can be used between the NGIS tool and the DB25 Power cable. Refer to “Extension Cable (3305-71)” on page 3.

17

Figure 2.12: DB25 Power Cable Connection to Cigarette Lighter

Receptacle

3 Connect the cables’s power plug into the vehicle’s ciga- rette lighter receptacle.

Note: Battery Adapter (212638) can be used to connect the cable’s power plug to the vehicle’s battery. Refer to “Battery Adapter (212638)” on page 5.

Figure 2.10: Adapter Connection to DB25 Power Cable

1Locate the required adapter and connect the adapter’s 8-pin connector to the cable’s 8-pin connector. For a description of the adapters, refer to “Vehicle Adapters” on page 4.

Figure 2.13: DB25 Power Cable Connection to Vehicle’s DLC

4 Connect the adapter’s connector to the vehicle’s DLC.

Note: The vehicle’s DLC is not always located under the dash as shown above.

Note: Some adapters may have more than one connec- tor or may have test leads instead of a connector. Whatever the case, make the required connections to the vehicle’s DLC.

5 Continue with the next section, “Step 3: Select the Diag- nostic Function” on page 18.

Figure 2.11: DB25 Power Cable Connection to NGIS Tool