Outback Power Systems GVFX, GTFX manual Master, Classic Slave

Master

With the Port 01 FX as the Master, press the <PORT> soft key to change the remaining Ports and designate the remaining FXs as Slaves. The MATE screen for Port 02 will look like this:

ADV/FX/STACK	--------P02
stack	Master
phase
DOWN INC	DEC PORT

ADV/FX/STACK	---------P02
stack	Master
phase

DOWN INC DEC PORT

•The MATE is now ready to program the FX plugged into Port 02 of the HUB.

•Master is the factory default value for each grid-inter- active FX.

•Pressing the <INC> soft key will keep the MATE’s attention on Port 02, but will change the stack phase to Classic Slave screen. Port 02 will then be assigned as a Classic slave. You can change the stacking phase by pressing the <INC> or <DEC> soft keys and change to a different port by continuously pushing the <PORT> soft key.

Note: There are no <OK> or <DONE> commands in the stacking menu. Whichever value—Master or Slave—shows up on the MATE screen will be assigned to the chosen Port (and FX) upon leaving that screen. It’s important to watch the Port number in the top right corner of each screen to be sure you’ve assigned it the desired status.

CLASSIC Slave

ADV/FX/STACK---------		P02
stack	Classic	Slave
phase		• PO2 is now assigned as a Classic Slave.
DOWN	INC DEC	PORT

13