RR 2150 Front Panel, FP1 Tone Off Defeat control see page

Owner’s Manual

RR 2150 Front Panel

FP1 Tone Off (Defeat) control (see page 19)

Press this button to take the tone controls out of the signal path so that they have no effect regardless of where they’re set. The blue LED in the button’s center will glow when the tone controls are inactive.

FP2 Bass control (see page 19)

Turn this knob to change the amount of low frequency information being sent to your speakers or headphones. The bass control is inactive when the Tone Off button (FP1) is depressed.

Note: When using small speakers – those with limited bass handling capability – be careful when increasing bass content, particularly if you’ve also selected any setting other than “Off” with the front panel Speaker EQ switch (FP15).

FP3 Balance control (see page 19)

FP5 Treble control (see page 19)

Turn this knob to change the amount of high frequency information being sent to your speakers or headphones. The treble control is inactive when the Tone Off button (FP1) is depressed.

FP6 Tuning Up (Menu Select) (see pages 20-21)

Press this button to tune to a broadcast frequency higher that the one currently selected. It is also used with the Function and Enter pushbut- tons (FP8 and FP9 respectively) to adjust tuner functions to match your preferences.

FP 7 Tuning Down (Menu Select) (see pages 20-21)

Press this button to tune to a broadcast frequency lower than the one currently selected. It is also used with the Function and Enter pushbuttons to to adjust tuner functions to match your preferences.

FP8 Function button (see pages 20-21)

This button is used to configure the RR RR 2150’s internal tuner.

FP9 Enter button (see pages 20-21)

Turn this knob to adjust for left-right imbalances in a source.

FP4 Front Panel Display

This display shows the selected input or radio station currently tuned, as well as menu items to help you use the RR 2150.

When setting up tuner functions with the Function (FP8) and the Tuning Up and Down buttons (FP6 and FP7 respectively), press this button to enter the choice shown to the unit’s memory.