Panasonic AG-AF100P CARD FULL, CHECK CARD, CANNOT SET, CARD ERROR, CANNOT PLAY, CANNOT DELETE, CANNOT RECORD, CHECK USB CABLE, PLEASE REFORMAT, CARD DOOR OPENED

Screen displays (continued)

Main warning displays

The main warning displays appearing on the LCD monitor or viewfinder are listed below. If a warning display is not listed, check carefully the message displayed.

■■C

CANNOT BE USED DUE TO INCOMPATIBLE DATA.

No use is possible because the standard for the data is different.

CANNOT DELETE.

Clip cannot be deleted.

CANNOT DELETE WITH THIS BUTTON

Clip cannot be deleted.

CANNOT PLAY.

No playback is possible.

CANNOT PLAY WITH THIS BUTTON

No playback is possible.

CANNOT RECORD PH MODE AND HA MODE INTO THIS CARD.

This card cannot be recorded to in PH mode or HA mode.

CANNOT RECORD.THE NUMBER OF CLIPS HAS EXCEEDED THE MAXIMUM LIMIT.

The maximum number of clips has been reached and no further clips can be recorded.

CHECK CARD.

Please check the card.

If an SD memory card that has been used before in another device or personal computer is used for the first time in this camera-recorder, CHECK CARD is displayed, and all operations may be disabled. In such a case, perform the following:

1Remove the SD memory card from the unit and insert it again. (Page 38 of Vol.1)

The unit recognizes the SD memory card and

cancels the CHECK CARD display.

2If the CHECK CARD display is not canceled even after removing and inserting the SD

memory card several times, check the contents of the card on a personal computer, and erase the entire data.

3Format the SD memory card in the unit. (Page 36 of Vol.1)

If the data on the card cannot be either read or erased on a personal computer, the SD memory card may be corrupted. Use another SD memory card.

CHECK USB CABLE.

Please connect the camera-recorder to a PC.

CANNOT SETTHE NUMBER OF INDEXES HAS EXCEEDED THE MAXIMUM LIMIT.

No further indexes can be set because the number of indexes will exceed the maximum limit.

CANNOT SET PRE-REC,CARD CAPACITY TOO LOW.

PRE-REC cannot be set as the remaining card capacity is low.

CARD DOOR OPENED.

The card door is open.

CARD ERROR.PLEASE REFORMAT.

Formatting has failed. The card needs to be reformatted.

CARD FULL.

The card is full.

CONTROL DATA ERROR HAS BEEN DETECTED.

An error has been detected in the control information.

■■D

DISCONNECT USB CABLE.

When switching from one mode to another, disconnect the USB connection cable.

■■I

INCOMPATIBLE CARD.PLEASE CHECK CARD.

This card may have been formatted in a format with different system frequency. Check the card.

(Continued on the next page)

48