BNC×1, 0.5 to 8 Vp-p BNC×1, 2.0 Vp-p
D-sub9-pin,RS-422A interface D-sub25-pin,RS-232C interface D-sub15-pin
BNC×1, AES/EBU format
Complies with SMPTE259M-C, 272M standard (BNC)
Phono×1, 600 Ω, –8 dBV Variable level, 1/4" phone, 8Ω
XLR×2, low impedance, +4/0/–20 dBu
300 Hz to 6 kHz ±3 dB
48 kHz
16 bits
20 Hz to 20 kHz (±1.0 dB)
Better than 85 dB (1 kHz, emphasis OFF, “A” weighted)
Less than 0.1% (1 kHz, emphasis OFF, standard level)
Less than –80 dB (1 kHz, between 2 channels)
Below measurable limits 20 dB
T1=50 μs/T2=15 μs (on/off automatic)
Weight and dimensions when shown are approximately. Specifications are subject to change without notice.
Other input/output connector
(Audio input connector)*
Analog input (CH1/CH2): XLR×2, 600Ω/high impedance selectable, +4/0/–20/–60 dBu
Digital input (CH1/CH2) (option): BNC×1, AES/EBU format
Serial digital input (option): Complies with SMPTE259M-C, 272M standard (BNC)
(Audio output connector)
Time code input*:
Time code output: RS-422A input/output: RS-232C:
Encoder remote:
Monitor output: Headphones:
Analog output (CH1/CH2): Digital output (CH1/CH2)
(option):
Serial digital output (option):
Frequency response:
Distortion:
Crosstalk:
Wow & flutter: Headroom: De-emphasis:
(Cue track)
(Video output connector)
Analog component output:
Analog composite output:
S VIDEO output:
Serial digital component output (option):
(Video signals adjustment)
Video output gain:
Video output chroma gain: Video output hue:
Video output setup: Video output sync phase: Video output SC phase:
AUDIO (Digital audio)
Sampling frequencies: Quantizing: Frequency response: Dynamic range:
Specifications
GENERAL
| | | | |
| Power supply: | AC 120 V, 50 – 60 Hz | |
| Power consumption: | AJ-D440; 120 W | |
| | AJ-D450; 150 W | |
| | |
| | | | |
Operating ambient temperature: 41°F to 104°F (5°C to 40°C) |
Operating ambient humidity: | 10% to 90% (no condensation) |
Weight: | AJ-D440; 33 lbs (15 kg) |
| | AJ-D450; 34.98 lbs (15.9 kg) |
Dimensions (W × H × D): | 16-3/4 × 6-15/16 ×16-3/8 inches |
| | (424 × 175 × 415 mm) |
Recording format: | DVCPRO format |
Recording tracks: | Digital video | Recorded in sub-code area |
| | Time code; | 2channels |
| | Digital audio; | 1 track |
| | Cue Track; | 1 track |
| | Control (CTL); | | |
Tape speed: | 33.820 mm/sec |
Recording time: | 184 minutes (with AJ-5P92LP) |
| | 66 minutes (with AJ-P66MP) |
Tape: | 1/4-inch thin magnetic layer metal tape |
FF/REW time: | Less than 3 min (with AJ-5P92LP) |
| | Less than 2 min (with AJ-P66MP) |
Editing accuracy*: | ±0 frame (using time code) |
Tape timer accuracy: | ±1 frame (using continuous CTL signal) |
Servo lock time: | Less than 0.5 sec. (color framing/ |
| | standby ON) | | |
VIDEO (Digital video)
Sampling frequencies: | Y; 13.5 MHz/PB, PR; 3.375 MHz |
Quantizing: | 8 bits |
Error correction: | Reed-Solomon product code |
(Digital IN/analog component OUT)
Video bandwidth: | Y; 30 Hz to 5.5 MHz (±1.0 dB) |
| PB, PR; 30 Hz to 1.0 MHz (±1.0 dB) |
S/N ratio: | Better than 56 dB |
K factor: | Less than 2% |
(Analog component IN/component OUT)
Video bandwidth: | Y; 30 Hz to 5.5 MHz (–1.5 dB to +1.0 dB) |
| PB, PR; 30 Hz to 1.0 MHz |
| (–2.0 dB to +1.0 dB) |
S/N ratio: | Better than 55 dB |
K factor: | Less than 2% |
(Analog composite IN/composite OUT)
Video bandwidth: | Y; 30 Hz to 4.5 MHz (–1.5 dB to +1.0 dB) |
DG: | Less than 4% |
DP: | Less than 3° |
Y/C delay: | Better than 20 ns |
K factor: | Less than 3% |
S/N ratio: | Better than 48 dB |
(Video input connector)*
Analog component input*: | BNC×3 (Y, PB, PR) |
| Y; 1.0 Vp-p, 75Ω |
| PB, PR; 0.486/0.7 Vp-p switchable, 75Ω |
| (75% color bar, 7.5% setup) |
Analog composite input*: | BNC×2, loop-through, 75Ω on/off |
S VIDEO input*: | S terminal (4-pin)×1 |
| Y; 1.0 Vp-p, 75Ω |
| C; 0.286 Vp-p (burst), 75Ω |
Reference input: | Analog composite |
| BNC×2, loop-through, 75Ω on/off |
Serial digital component input | Complies with SMPTE259M-C standard, |
(option)*: | BNC×2, active through |
* Items marked with an asterisk ( * ) indicate AJ-D450 only.
BNC×3 (Y, PB, PR)
Y; 1.0 Vp-p, 75Ω
PB, PR; 0.486/0.7 Vp-p switchable, 75Ω (75% color bar, 7.5% setup)
BNC×3
Video1/video2/video3 (superimpose on/off)
S terminal (4-pin)×1 Y; 1.0 Vp-p, 75Ω
C; 0.286 Vp-p (burst), 75Ω
Complies with SMPTE259M-C standard, BNC×3
±3 dB
±3 dB Control from ENCODER
±30° REMOTE connector
±15 IRE
±2 μs
±180°
