Operating procedure

Sub carrier phase adjustment

1Select the first camera to be adjusted by pressing the CAM CONTROL button.

2Press the MENU button to display the menu on the LCD panel.

3Turn the CONT dial to display the G/L SETTING menu.

4Push the CONT dial straight down twice to display SC COARSE on the bottom line of the LCD. The sub carrier phase can now be adjusted coarsely by turning the CONT dial.

When the CONT dial is pushed three times, SC FINE appears, and the sub carrier phase can now be adjusted finely by turning the CONT dial.

5Keep adjusting the SC COARSE and SC FINE phase so that the sub carrier (colour) phase of the video signal output is aligned with the colours of the programme output (split colour bar output) of the video switcher or other unit that serves as the reference.

The colour phase can be adjusted more accurately if a vectorscope is used.

6Select the next camera by pressing the CAM CONTROL button, and adjust the sub carrier phase of the next camera. Repeat this for all the connected cameras.

White

Yellow

Cyan

Green

Magenta

Red

Blue

 

 

 

 

 

 

 

Black

Colour bars of camera

 

Split line

Colour bars of special effects unit

$ Video adjustment of cameras

This adjustment is performed when the pedestal of a multiple number of cameras is to be brought into alignment.

1Select the first camera to be adjusted by pressing the CAM CONTROL button.

2Set the lens iris to manual, and stop it down.

3Use an oscilloscope or waveform monitor to adjust the pedestal level to correspond to the reference level using the total pedestal dial.

4Select the next camera by pressing the CAM CONTROL button, and adjust the pedestal of the next camera. Repeat this for all the connected cameras.

Adjust the pedestal level to the reference level.

13 (E)