Parts and their function

$ Front panel

1 2 3 4

5

 

6

 

 

C

8

D

9 7

: ;

E

 

<

F

>

= ?

G

 

 

H

@

 

A

 

ENGLISH

B

1TALLY lamps [1] to [5]

When tally signals are supplied to the (L) tally/INCOM connectors [1] to [5] on the rear panel, the lamps with the numbers corresponding to those connectors light up. When tally signals are supplied to the tally connectors [1] to [5] of the pan/tilt control panel, if this control panel is connected to the ROP, the lamps with the numbers corresponding to those connectors also light up.

2LCD CONTRAST control

Use this to adjust the contrast of the LCD panel.

3DATA SET button

Press DATA SET button and (6) CAM CONTROL buttons [1] to [5] at the same time to synchronize the setting data stored in the cameras selected with the setting data stored in the ROP or vice versa.

Press only DATA SET button to synchronize the setting data stored in all cameras connected to the ROP.

≥In the case of the AW-E300, AW-E300A, AW-E600 or AW-E800A cameras, the data stored in the ROP is transferred to the cameras.

In the case of the AW-E350, AW-E650, AW-E655 or AW-E750 cameras, the data stored in the cameras is transferred to the ROP.

Data transfer takes two to three or so minutes.

≥Press this button when the ROP is used for the first time, or when the camera is replaced.

I

J

4MENU button

Press this to turn the setting menu ON or OFF.

5LCD panel

This displays the current settings.

6CAM CONTROL buttons [1] to [5]

If the cameras are connected directly to the ROP, the button lamps corresponding to numbers of the buttons selected light, and the selected cameras can be controlled by pressing buttons [1] to [5].

If the ROP is connected to the pan/tilt control panel for use, the cameras installed to the pan/tilt head which is connected to the pan/tilt control panel can be selected.

The buttons corresponding to the selected numbers light, and selected cameras can be controlled.

When the ROP is connected to the pan/tilt control panel, the camera selection function can be set to “From pan/tilt control panel only”, “From ROP only” or “From both”, depending on the setting selected by the pan/tilt control panel. For further details, refer to the instruction manual of the pan/tilt control panel.

4 (E)