Installation
<When a large lens is used>
A large lens can be attached to the
Use any of the large lenses listed below.
HA42 × 13.5 BERD or A42 × 13.5 BERD made by Fujinon Corporation
HJ40 × 14B
No other lenses can be used.
How to attach the lens
Remove the lens hood and zoom lever of the large lens.
Zoom lever
Lens hood
Attach the lens holder (supplied) to the lens supporter mounting screw on the bottom of the lens.
| Lens holder |
| Mounting |
Lens supporter | screw |
mounting screw | Allen key |
| |
| Washers |
M6 mounting screws (supplied) are used for a Fujinon lens; M5 mounting screws (supplied) are used for a Canon lens.
Fit the camera and lens together.
Mount the camera mount on the top panel of the camera. For details on how to mount it, refer to the section on how to mount the cameras and mount.
Connect the supplied camera cable to the I/F REMOTE connector at the back of the camera.
In order to make it easier to connect the cable after stowing the lens unit, the cable must be connected here when a large lens is to be used.
Place the assembly of the camera mount, camera and large lens inside the housing from the front edge of the lens.
Hook a piece of string (supplied) around the lens barrel, and stow the assembly inside the housing. At this point, with the assembly tilted at an angle of around 45 degrees () as shown in the figure below, position the entire lens motor drive area at the front right inside the inner wall of the housing and the lens holder in front of the I/F connector, and insert it diagonally with the front end of the lens first.
After stowing the lens unit, return the tilted camera to its original angle (), place the camera mount up against the support ribs on both sides of the housing, and fit these areas between the plate nut and mount.
String
Lens holder
Lens motor 
drive area
Camera mount
support ribsI/F connector area of the housing
Lens holder (Insert this in
Camera mount screwsfront of the I/F connector.)
Camera mount | Lens motor drive area |
22
