Installation
Check whether the “
Lens holder
Metal bracket
Check the front panel through the glass.
Check whether the center of the lens and center of the glass are aligned.
Also visually check from the front of the housing whether the centers of the lens and camera are aligned. If they deviate significantly, turn the lens up/down position adjustment screw on the lens holder to move the
lens position up or down. (When the screw is turned clockwise, the lens position moves up; conversely, when it is turned counterclockwise, it moves down.)
Lens up/down position adjustment screw
Downward Upward
Lens holder
Connect the camera with the lens to the interior of the housing using the cable.
(Refer to the section on the connections.)
Bring the front edge of the lens and inside of the glass as close together as possible. Bear in mind the following points.
(1)Set to a position where the lens and glass will not come into contact when the lens is maximally zoomed out.
(2)Check that the inside surface of the glass and lens glass surface are more or less parallel with each other and that the thermostat sensor and lens do not touch.
Upon completion of all the settings, securely tighten up the 4 camera mount screws.
Close the top cover, and tighten the two bolts for opening and closing the top cover securely.
Thermostat sensor | Check that the “ | ” |
|
lens holder is fitted into the metal bracket.
23